Allmand LSC 2.1 Display Module Manuel D'instructions page 25

Clear Fault
Whenever a fault occurs, the fault must be cleared
before the LSC control will allow the engine to start
again.
Follow these steps to clear a fault:
1. From the Main Operating screen, press the Menu
button. The Menu screen will appear.
2. Press the DOWN arrow twice to highlight
Maintenance.
3. Press the Enter button. The Maintenance screen
will appear.
4. With Clear Fault highlighted (see Figure 18), press
the Enter button. The display will return to the
Main Operating screen. The fault message will no
longer be displayed in the upper left corner of the
Main Operating screen.
LSC 2.1 Display Module
Figure 18
21
en