Gps Location Setup Screen - Allmand LSC 2.1 Display Module Manuel D'instructions

GPS Location Setup Screen

How to navigate to the GPS Location Setup screen:
1. On the Main Operating screen, press the Menu
button. The Menu screen will appear.
2. Press the Enter button. The Automatic Control
Setup screen will appear.
3. Press the DOWN arrow three times to highlight
GPS Location Setup.
4. Press the Enter button. The GPS Location Setup
screen will appear (see Figure 11).
The GPS Location Setup screen is used for setting up
the GPS location of the unit. The GPS location is used
to determine the sunrise and sunset times.
The GPS latitude and longitude are in decimal
degrees. The coordinates in Figure 9 are for
Allmand Bros., Inc., Holdrege, Nebraska, USA.
Choose positive or negative latitude and longitude
according to these rules:
• If the location is in the Northern Hemisphere, use
a plus sign (+) for the latitude.
• If the location is in the Southern Hemisphere, use
a minus sign (−) for the latitude.
• If the location is in the Eastern Hemisphere, use a
plus sign (+) for the longitude.
Figure 11
• If the location is in the Western Hemisphere, use a
minus sign (−) for the longitude.
To change the coordinates:
1. Use the UP/DOWN and LEFT/RIGHT arrows to
move between the fields.
2. Press the Adjust button to select a field. The
selection will begin flashing green.
3. Use the UP and DOWN arrows to change the
number.
4. Press the Save button.
5. Repeat this process until the correct coordinates
are displayed.
12