Block Heater Setup Screen - Allmand LSC 2.1 Display Module Manuel D'instructions

Block Heater Setup Screen

How to navigate to the Block Heater Setup screen:
1. On the Main Operating screen, press the Menu
button. The Menu screen will appear.
2. Press the Enter button. The Automatic Control
Setup screen will appear.
3. Press the DOWN arrow once to highlight Block
Heater Setup.
4. Press the Enter button. The Block Heater Setup
screen will appear (see Figure 9).
The Block Heater Setup screen is used to set the
amount of time the engine block heater runs before
engine start-up.
Use the UP and DOWN arrows to move between
Block Heater and Run Time Before Start.
To change between Enabled and Disabled for the
block heater:
1. Press the Adjust button. The selection will begin
flashing green.
2. Use the UP (Enabled) and DOWN (Disabled)
arrows to change the selection.
3. Press the Save button.
Figure 9
To change the Run Time Before Start minutes:
1. Press the Adjust button. The selection will begin
flashing green.
2. Use the UP and DOWN arrows to change the
number of minutes. The range is 1 to 60 minutes.
3. Press the Save button.
10