Allmand LSC 2.1 Display Module Manuel D'instructions page 23

The low fuel alarm will sound when the fuel level
drops below the specified percentage.
To change the Low Fuel Alarm Percent setting:
1. Use the UP and DOWN arrows to highlight Low
Fuel Alarm Percent.
2. Press the Adjust button to select the field. The
selection will begin flashing green.
3. Use the UP and DOWN arrows to change the
percentage. The range is between 10% and 50%.
4. Press the Save button.
The engine crank time is how long the engine will
crank before it starts.
To change the Engine Crank Time setting:
1. Use the UP and DOWN arrows to highlight Engine
Crank Time.
2. Press the Adjust button to select the field. The
selection will begin flashing green.
3. Use the UP and DOWN arrows to change the
number of seconds. The time range is between
3 and 20 seconds.
4. Press the Save button.
To change the Glow Plug Cycle Time setting:
1. Use the UP and DOWN arrows to select Glow
Plug Cycle Time.
2. Press the Adjust button to select the field. The
selection will begin flashing green.
3. Use the UP and DOWN arrows to change the
number of seconds. The time range is between
5 and 30 seconds.
4. Press the Save button.
To change the Fuel Tank Size setting:
1. Use the UP and DOWN arrows to highlight Fuel
Tank Size.
2. Press the Adjust button to select the field. The
selection will begin flashing green.
3. Use the UP and DOWN arrows to change the
gallon size. Possible sizes are 30 gallon or 100
gallon.
4. Press the Save button.
To change the Frequency setting:
1. Use the UP and DOWN arrows to highlight
Frequency.
LSC 2.1 Display Module
2. Press the Adjust button to select the field. The
3. Use the UP and DOWN arrows to change the
4. Press the Save button.
To change the Glow Plugs Cycle After Start setting:
1. Use the UP and DOWN arrows to highlight Glow
2. Press the Adjust button to select the field. The
3. Use the UP and DOWN arrows to change
4. Press the Save button.
To change the Fuel Rate setting:
1. Use the UP and DOWN arrows to highlight Fuel
2. Press the Adjust button to select the field. The
3. Use the UP and DOWN arrows to change the fuel
4. Press the Save button.
To change the Low Fuel Engine Shutdown setting:
1. Use the UP and DOWN arrows to highlight Low
2. Press the Adjust button to select the field. The
3. Use the UP and DOWN arrows to change
4. Press the Save button
To change the Engine Warm Up Time setting:
1. Use the UP and DOWN arrows to highlight Engine
2. Press the Adjust button to select the field. The
3. Use the UP and DOWN arrows to change the
4. Press the Save button.
19
selection will begin flashing green.
freqency. Possible frequencies are 50 Hz or 60
Hz.
Plugs Cycle After Start.
selection will begin flashing green.
between Enabled and Disabled.
Rate.
selection will begin flashing green.
rate (gallons used per hour). The fuel rate range is
between 0.10 and 10.00 gallons per hour.
Fuel Engine Shutdown.
selection will begin flashing green.
between Enabled and Disabled.
Warm Up Time.
selection will begin flashing green.
number of seconds. The time range is between 0
and 120 seconds.
en