Auto-Mode - Sunset/Sunrise-Based Start/Stop Screen - Allmand LSC 2.1 Display Module Manuel D'instructions

Auto-Mode – Sunset/Sunrise-based Start/Stop
Screen
How to navigate to the Auto-Mode screen:
1. On the Main Operating screen, press the Menu
button. The Menu screen will appear.
2. Press the Enter button. The Automatic Control
Setup screen will appear.
3. Press the DOWN arrow twice to highlight Sun-Set
Control Setup.
4. Press the Enter button. The Auto-Mode screen will
appear (see Figure 10).
The Auto-Mode screen is used for changing the
Auto-Start program's sunrise and sunset settings.
To change the number of minutes:
1. Use the UP and DOWN arrows to toggle between
the two fields.
2. Press the Adjust button to select a field. The
selection will begin flashing green.
3. Use the UP and DOWN arrows to change the
number of minutes. The range is 0 to 180 minutes,
in 10-minute increments.
4. Press the Save button.
LSC 2.1 Display Module
Figure 10
11
en