Publicité
Les langues disponibles
Les langues disponibles
2. SITE PREPARATION
ROUGHING-IN DIMENSIONS
K-3520 – 29-1/4" (74,3cm)
K-3521 – 27-1/4" (69.2cm)
1" (2.5cm)
3-5/8"
(9.2cm)
C L OF OUTLET
12" (30.5cm)
REMOVE EXISTING TOILET
NOTE: Carefully inspect the new fixture for any sign of damage
before removing the existing toilet.
Turn off the water supply.
Flush the toilet, and sponge out all remaining water from the tank
and bowl.
Disconnect the supply valve, and remove the old tank and bowl.
Remove the old gasket from the floor and closet flange with a putty
knife.
Remove the old T-bolts (the T-shaped bolts in the closet flange),
and discard.
CAUTION: Risk of hazardous gases. If the new toilet is
not installed immediately, temporarily stuff a rag in the closet
flange.
ROUGH-IN PLUMBING
Turn off the water supply.
Install or relocate the supplies and outlets as necessary to conform
to the roughing-in dimensions. For shut-off valve location, see
Fig. #3.
A
1007281-2-
20-1/8" (51.1cm)
28-3/8"
(72.1cm)
14-1/4"
(36.2cm)
10-1/4"
(26cm)
3/8" N.P.T. SUPPLY
5-3/4"
(14.6cm)
Fig. #1
2
K-3520
FRONT OF BOWL
15-7/16"
(39.2cm)
6-1/8"
(15.6cm)
9-1/2" (24.1cm)
K-3521
FRONT OF BOWL
13-7/8"
(35.2cm)
6-1/8"
(15.6cm)
9-1/2" (24.1cm)
Closet Flange
Fig. #2
Kohler Co., Kohler, WI U.S.A.
Publicité
