Controller Operation - mspa Alpine Manuel D'utilisation

CONTROLLER OPERATION

Heater Button
Bubble Button
Up Button
Temperature display: press RESET on PRCD, the screen shows current temperature
Heater Button:
Meanwhile, the filter will automatically run and test for 15s. If there is no abnormality, the heating
HEATER
starts until the temperature reaches setting value. After the current water temperature drops
below the setting temperature, the heating system will restart automatically. When the HEATER
button is red, the heating system is activated. When the HEATER button is green, the heating
system is at rest as the water is at the set temperature.
Filter Button:
display green when activated.
FILTER
NOTE: Filtration cannot be turned off when Heating is activated. When the Heating function is
turned off, Filtration will be stopped after 30 seconds. Filtration function can be then activated
separately.
NOTE: Auto-filtration system every 4 hours.
Bubble Button:
for 10-mintues feature. The light of Bubble button displays green when activated.
BUBBLE
HEATER
BUBBLE
UP
Press HEATER button to turn the function on/off.
Press FILTER button to turn the function on/off. The light of FILTER button
To activate the bubbling massage function, which has a 20-minutes auto off
°C
FILTER
TIMER
DOWN
15
Filter Button
Timer Button
Down Button