Control Panel Operation - mspa Mont Blanc P-MB04 Manuel D'utilisation

CONTROL PANEL OPERATION

ON/OFF Button:
LCD displays the current temperature and backlight is white when the power is on, all
functions can be opened.
Bubble Button:
massage power is level 2 (500W)
(720W)
the BUBBLE button for 3 seconds.
NOTE: The bubbling massage function will be shut down automatically after every 20
minutes operation for safety concern. It can not be operated within 10 minutes after shut
down. The bubbling massage function will be filtered automatically after 4-hour.
Filter Button:
activated.
NOTE: Filtration cannot be turned off when heating is activated. When the Heating function
is turned off, Filtration will be stopped after 30 seconds. Filtration function can be then
activated separately.
NOTE: Auto-filtration system every 4 hours.
Heater Button:
same time. The heater will heat the spa water until the water temperature reaches the pre-set
temperature. After the current water temperature drops below the set temperature, the
heating system will restart automatically. The Heater icon shows when the heating system is
activated. When the Heater icon is flashing, the heating system is at rest and the water is at
set temperature.
NOTE: If you want to open the HEATING and FILTRATION functions, just press on the
HEATER button.
Temperature Adjustment Buttons:
Down button, and the LCD screen flashes to display the set temperature. The temperature
interval is one degree. The LCD displays the current temperature if no further operation more
than 3 seconds.
NOTE: The default temperature is 38°C(100°F).
NOTE: Temperature adjustment ranges from 20°C(68°F) to 42°C(108°F).
To activate the control panel.
Can adjust among 3 levels of bubbling power. The default bubbling
. Press again made to level 1 (300W)
Activate the filter pump. The Filter icon shows when the filtration system is
Use this button to activate the HEATING and FILTRATION function at the
16
1. ON/OFF Button
2. Bubble Button - Adjust the bubble
level by pressing the button
(L1:300W, L2: 500W, L3:720W)
3. Filter Button
4. Heater Button
5. Temperature UP & DOWN Button
6. Celsius/Fahrenheit Toggle Button
7. Ozonator Button
. Press the BUBBLE button again, switching to level 3
. To shut down the function, press
To adjust the current temperature, press the UP or