Troubleshooting - mspa Alpine Manuel D'utilisation

TROUBLESHOOTING

PROBLEM
NO DISPLAY ON
THE CONTROL
PANEL
SPA LEAKING
NOT HEATING
PROPERLY
BUBBLE AIR
BLOWER DOES
NOT WORK
CAUSE
Power failure
PRCD is off
PRCD broken
Spa inlet/outlet connection not
securely tight
Drainage valve is not closed
completely
Water leaks from the spa
pool body
Temperature set too low
Heating element failed
Water level is not at the
minimum water line
Bubble motor failure
Auto-off 10 minute
Check power source
Reset PRCD
Contact the MSpa Service Center
Tighten the inlet and outlet
connection
Contact the MSpa Service Center, if spa is
still leaking
Repair the leaking hole/spilt with the repair
kit material
Set a higher temperature
Contact the MSpa Service Center
Add more water to the minimum line
Contact the MSpa Service Center
Waiting for 10 minutes and turn on the
Bubble button again
21
SOLUTION