mspa Alpine Manuel D'utilisation page 22

PROBLEM
FILTER PUMP
DOES NOT WORK
SPA TUB IN AN
ABNORMAL
SHAPE
SPA LOOSES AIR
PRESSURE
WATER NOT
CLEAN
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
CAUSE
Power failure
Filter stuck by dirt or other objects
Water level is not at the
minimum water line
Extra air pressure by strong
sunshine
Air valve got loosen
Hole or split on the spa tub
Insufficient filtering time
Dirty filter cartridge
Improper water maintenance
Check the power source
Clean or replace filter cartridge
Add more water to the minimum line
Please check the air pressure and release
air if necessary
During hot weather, it recommended to
check if it is necessary to release some air to
avoid any possible damage to the spa pool
Fill up the tub with air, make sure the air
valves are secure, replace if necessary
Put soap water in a squirt bottle and spray
on seams. If there is a leak it will bubble.
After you find the leak, clean and dry the
leaking area, then use the repair patch
comes with your spa. Check the repair
section on P19
Increase filtration time
Clean or replace the filter cartridge in time
Refer to the chemical manufacture's
instruction
22
SOLUTION