Controller Operation - mspa Lite LS04-NA Manuel D'entretien

6
Make sure the filter cartridge remains in place when the spa is
filled with water.
NOTE: It is recommended to fill the spa with lukewarm water for quick heating and energy saving.
NOTE: Ensure the manometer points to the Green section when the spa is filled with water.
WARNING:
Do not drag the spa after filling it with water.
Do not operate the spa until the water reaches the Minimum line.
The water temperature should not be higher than 40°C / 104°F.
Heating the water
Place the cover over the spa. Refer to "Controller operation" to turn on the heater.
The hourly heating rate is around 2°C - 2.5°C (2.5°F - 3.5°F) for a 2-person spa or a 4-person square spa, 1.5°C - 2°C (2.5°F - 3.5°F) for a 4-person round
spa, and 1.2°C - 1.8°C (2°F - 3°F) for a 6-person spa.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.

CONTROLLER OPERATION

Buckle Lock Operation
LED Display
Heater Button
Bubble Button
Up Button
7
Lock
°C
°F
HEATER FILTER
BUBBLE TIMER
UP DOWN
10
Unlock
Filter Button
Timer Button
Down Button