Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SYMBOL USAGE
DANGER
Indicates information about safety practices which, if not
followed, may result in serious injury or death.
.......................................................................................
Indicates information about safety practices which, if not
followed, could result in personal injury or are necessary to
WARNING
prevent fire or equipment overheating.
.......................................................................................
Indicates helpful information for installation or usage, but
does not contain personnel or equipment safety related
NOTE
information.
ABOUT YOUR TURBODX EV CHARGING STATION
Welcome to your TurboDX EV Charging Station – our easy-to-use, compact power
supply for your electric vehicle's on-board charger. The charger supplies and
manages AC power to your electric vehicle and is compatible with a variety of
battery electric and plug-in hybrid vehicles.
KEY FEATURES
•
Compact design
•
Overheating protection
•
Network flexibility (select models)
•
Quick-read status indicators
•
Underwriters Laboratories (UL) listed
•
SAE J1772 compliant
•
Auto-restart in event of ground fault or power outage
240 VAC Operation:
the charger requires either a 240 VAC split phase or a 208
VAC single phase dedicated circuit. It draws a maximum of either 16-amp or
32-amp continuous current and requires a 20-amp or 40-amp rated circuit breaker.
WARNING: This system will not work with three phase three wire delta (high-leg).
Voltage from line to ground must be 120 volts.
It is recommended that electrical circuits for use with your charger be
WARNING
installed by a licensed, qualified electrician. To avoid serious injury or death,
installation must comply with the provisions of the National Electric Code
(NEC) and all local codes. In cases of conflict between local codes and the
NEC, local codes shall take precedence.
2
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electric current to reduce
WARNING
the risk of electric shock. The TurboDX will not operate unless the ground
is connected. In commercial installations where multiple circuits share a
conduit make sure not more than 2 DX share the same ground.
WARNING
Do NOT DROP coupler.
................................................................................................................
If the output cable becomes separated from the charger module or the
WARNING
charge coupler, DO NOT ATTEMPT TO REPAIR THE CABLE YOURSELF.
Contact Customer Support for assistance.
................................................................................................................
When using your charger, basic precautions should always be followed,
including the following:
DANGER
•
See warnings on side of charging station. Read warnings before
operating the unit the first time. Read all instructions in this guide
before using this product.
•
Children should be supervised when in the vicinity of the charger while
plugged in.
•
Do not put fingers into the electric charge coupler.
WARNING
•
Do not use in a hazardous locations. If used in a commercial garage
classified for internal combustion engine vehicles due to vapors of
flammable liquids (gasoline) being present it must be installed per NEC
code Article 511 (NFPA 70).
3
Publicité
Chapitres
Table des Matières
