Publicité
Les langues disponibles
Les langues disponibles
Charging
Starting charging
1.
2.
3.
After the battery capacity has been set, the charging current calculated from this is
shown on the display
4.
5.
Charger detects that the battery is connected, carries out a self test and starts charging.
Important! If the battery voltage is < 1.0 V, the battery will not be automatically detected.
Charging must be started manually.
CAUTION! Risk of damage when attempting to charge a faulty battery.
Before charging, ensure that the battery to be charged is fully functional.
CAUTION! When refresh charging is selected
Refresh charging may damage the on-board electronics. Before beginning
refresh charging, disconnect battery from vehicle power supply.
Select battery type and corresponding operating mode
Standard wet charging
Set the capacity of the battery to be loaded.
Connect (+) charging terminal to positive pole on battery
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems.
Self test
Refresh wet charging
E.g.: charging
9
User wet charging
Publicité
