Publicité
Les langues disponibles
Les langues disponibles
External power supply
Starting the
1.
external power
supply
2.
3.
4.
5.
6.
Important! Start external power supply manually if:
-
-
Starting the
1.
external power
supply manually
For external power supply, select FSV/SPLY mode
Connect (+) charging terminal to positive pole on battery
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems
Charger detects that the battery is connected, carries out a self test and starts
external power supply.
Self test
E.g.: FSV/SPLY
Press the Info button to display the parameters in the following sequence:
-
actual charging current
-
actual battery voltage
-
amount of charge (Ah) fed in so far
-
energy (Wh) fed in so far
-
length of time charging so far
there is no battery connected to the vehicle
the battery voltage on the connected battery is < 1.0 V
Once the charging terminals are connected, press start/stop button for approx. 5
secs
WARNING! Risk of serious damage as a result of incorrectly connected char-
ging terminals. The reverse polarity protection facility is inoperative if the
external power supply is started manually. Connect charging terminals to
correct poles and ensure proper electrical connection to vehicle terminals.
-
the maximum voltage command value set in the
USER menu is shown in the top half of the display
-
the current parameters are shown in the bottom
half of the display.
13
Publicité
