Washer Installation (Nvx Range); Instructions For Normal Operation; Pump Manual Activation; Maintenance - Videotec WASNX Manuel D'instructions

6.5 Washer installation (NVX
range)
The camera, if equipped with a wiper, can be
equipped with an external pump that provides water
to clean the glass.
Fig. 31
To complete installation of the washing system, use
the kit supplied with the camera.
Insert the head of the nozzle (01) on the support (02)
by tightening the nut (03).
01
Fig. 32
Fasten the nozzle and the support assembled by
using one of the accessory holes (01) on the front of
the housing. Tighten the screw and the washer (02).
Insert the delivery pipe of the nozzle (03). Secure the
delivery pipe to the support with a clip (04).
02
Fig. 33
12
02
03
01
03 04
7 Instructions for normal
operation

7.1 Pump manual activation

Close the contact (button, switch, etc.) to activate
the wash system. Open the contact to shut-off water
supply.
N L
a
Fig. 34

8 Maintenance

8.1 Replacing the solenoid valve

Maintenance must be performed with the
power supply disconnected and the circuit-
breaker open.
Dismantle the support plate (01). Dismantle the
solenoid valve (02) from the support plate and
replace it.
02
Fig. 35
01
MNVCWASNX_2222_EN