Preparing The Product For Use; Unpacking; Safely Disposing Of Packaging Material; Preparatory Work Before Installation - Videotec WASNX Manuel D'instructions

5 Preparing the product for
use

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
5.3 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Glass wash system
• Bolts and screws
• Washer semi-rigid pipe (with nozzle)
• Hydraulic joints
• Delivery pipe
• Instruction manual
6
5.4 Preparatory work before
installation

5.4.1 Product opening

Unscrew the 2 side screws to open the cover.
Fig. 3
Unscrew the safety screw (01) and lift the casing (02).
01
Fig. 4

5.4.2 Drilling the box (optional)

There are 2 holes on the side of the product,
protected by sealing rings. The 2 holes enable
passage of the power supply cable of the solenoid
valve and the delivery pipe. Additional holes can
be made at the base or on the other side. The holes
should be protected by sealing rings.
Fig. 5
02
MNVCWASNX_2222_EN