Assembly Of The Seal Rings (Optional); Assembly On Supports - Videotec WASNX Manuel D'instructions

5.4.3 Assembly of the seal rings
(optional)
During assembly, be careful not to damage
the rubber and thereby reduce its air-
tightness.
Insert the conical part of the sealing ring in the hole.
Tighten the conical part of the sealing ring with a
pliers or a similar tool.
Fig. 6
Pull the sealing ring allowing it to pass through the
hole until the conical part is completely out. In the
final position, the sealing ring should completely
close the passage hole.
Fig. 7
RATIO BETWEEN THE DIMENSIONS OF THE SEALING RINGS AND THE
DIAMETER OF THE USABLE CABLES
Sealing ring Ø passage hole
(mm)
M16 16.5
M20 20.5
Tab. 1
MNVCWASNX_2222_EN

5.4.4 Assembly on supports

The product can be fastened directly to the wall or
the floor using the holes present.
Fig. 8
The box can also be assembled on a pole collar or
corner adaptor module.
Ø cable (mm)
From 5 up to 9
From 8 up to 12
Fig. 9
Fig. 10
Pole mounting.
Fastening with corner adaptor module.
7