Installation; Installation And Loading Of The Pump - Videotec WASNX Manuel D'instructions

6 Installation

Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
6.1 Installation and loading of
the pump
We recommend filling the tank with water
at ambient temperature. If using the pump
at temperatures below 3°C (37.4°F) add
some glass cleaner antifreeze liquid to the
water.
During installation or maintenance operations of the
pump, you can leave the tank in place or remove it. To
remove the tank (01) loosen the metal clips (02) and
release the connection pipe (03) by exerting pressure
on the fast connection joint (04).
02
01
02
Fig. 11
Reduce any residual pressure in the tank using the
safety valve.
Fig. 12
8
03
04
Undo the top body of the pump (01) by turning it
anti-clockwise and removing it. Fill the tank (02).
01
02
Fig. 13
Pressurise the tank pumping with the handle until
the indicated pressure is reached: 4Bar (without
accessories), 6Bar (antistatic water delivery pipe, 30m
(98ft), WEXTUB30). Turn the handle on the body of
the pump to its safety position.
Fig. 14
Pass the delivery pipe (01) through the sealing ring
(02). Connect the delivery pipe to the solenoid valve
(fast connector joint).
01
02
Fig. 15
MNVCWASNX_2222_EN