Publicité
Les langues disponibles
Les langues disponibles
Product description
SE Cylinder is intended to hold the domestic hot water. A main unit element is vitreous
enamel coated steel tank. Magnesium anode creates additional active anticorrosion
protection. Thermal insulation ensures high thermal accumulation.
SE Cylinder is suitable for fitting an immersion heater with thermostat (e.g. GRW 1.4,
GRW 2.0,..). The immersion heater must be fitted in cork 1½ [7].
A maximum length of immersion heater:
-
360 mm (Cylinders of 140, 200 litres)
-
550 mm (Cylinders of 250,300 litres)
-
600 mm (Cylinders of 400 litres)
-
670 mm (Cylinders of 500 litres).
SE Cylinder is intended for storing and heating the water (cylinder with an immersion
heater) in residential buildings, municipal dwellings, sanitary rooms etc. It's designed
for vertical installation only.
Assembly and operating instructions
-
Read and strictly follow this assembly and operating instructions to ensure
a long life and reliable cylinder operation.
-
The manufacturer of this cylinder will not be liable for any damages due to the
failure to follow the assembly and operating instructions.
-
During all work related to the installation, servicing or maintenance of the device,
the principles of health and safety, explosion protection, fire protection and
environmental protection must be observed in accordance with the applicable
requirements and regulations in the respective country.
-
The cylinder must not be installed in rooms where the temperature may drop below
0°C.
-
The cylinder installation and initial start-up as well as all electrical and hydraulic
work must be performed by a qualified professional installer.
-
Must not exceed the rated temperature of 80°C! tanks (250l, 300l, 400l and 500l).
In tanks 140l, 200l, must not exceed the rated temperature of 95º
PL;EN;DE;FR-042_f.1299
EN
17
Publicité
