BH FITNESS G2383N Instructions De Montage Et Utilisation page 14

6. FITTING THE FOCUS BAR
SIDE COVERS TO THE FOOT
BARS.-
Next fit the footrest covers (18) & (19)
with the bottom of the joints on the
right side, Fig.7. Use screws (34) (38)
to screw them together. Then do the
same with the other covers (18) & (19)
on the left-hand side.
Fit the connecting rod covers (20) and
(21), screw them in with the screws
(33).
7. FITTING THE HANDLEBAR.-
Insert the pulse cable (13). Attach the
handlebar (9), attach the front cover
(40) and screw in the knob (41). Fig.8.
Place the bottle holder (24) in the
main post and screw it in with the
screws (33).
8. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE
Take hold of the cable (12), which is
sticking up out of the main post (4),
Fig.9, and plug it into the connector of
the electronic unit (10), as shown in
Fig.9
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(13), sticking out of the main post (4),
and plug them into the connectors (14)
located at the back of the monitor (10),
as shown in Fig.9.
ATTACHING THE MONITOR.-
Release screws (100), Fig.9, at the
back of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(4) in the direction of the arrow, Fig.9,
push the cables down into the main
post making sure not the pinch any of
the cables. Replace the screws (100)
removed previously.
Tighten the monitor with screws (101),
screw the right (23) and left (22) cover
with screws (33).
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
LEVELLING.-
Once the unit has been placed into its
fi nal position, make sure that it sits fl
at on the fl oor and that it is level. This
can be achieved by screwing the
adjustable feet up or down.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (59)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.12. Store your unit in a dry place,
preferably not subject to changes in
temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
14