Publicité
Les langues disponibles
Les langues disponibles
5) Connect the power supply and start the space heater.
6) Using the gas supply system pressure regulator, adjust the p
value and is stable.
7) Using the gas valve pressure regulator (14), adjust the p
and is stable.
8) Turn the space heater off and on at least a couple of times and check that the p
9) If necessary, take one of the pre-printed "READY FOR ..." labels and fill it in with the details of the adjustment
category chosen.
Warning
The "READY FOR..." label must mandatorily indicate the gas category setting for the space heater in order to
avoid any possible misinterpretation or misuse.
It is the installer's exclusive responsibility to verify this correspondence at the end of the installation.
L-L 304.00-BM
EN
level reading until it corresponds to the required
a
level reading until it corresponds to the required value
b
and p
levels remain unchanged.
a
b
66 / 116
Publicité
