Table des Matières
Publicité
Case 2 with relay utilisation
Case 2 with transistor utilisation
How to connect the outputs of the controller
The following figure shows a typical logic output
connection (relay coil) but any other device may be
connected e.g. a LED, a computer, etc., and the
related simplified circuit of the controller. The fig-
ure example refers to the programmable set point
signal on pins 11 and 9.
Typical output connection 1
J2 - Serial
This is a 9 pin D-type serial input/output connector
to control via an RS 232 or RS 485 connection the
Mini-TASK AG81.
PIN N.
1
+5 V (OUT)
2
TX (RS232)
3
RX (RS232)
4
Not used
5
GND
6
A + (RS485)
7
Not used
8
B - (RS485)
9
Not used
A serial communication kit with a serial cable and
the Navigation Software is available (optional).
79/84
TECHNICAL INFORMATION
SIGNAL NAME
87-901-003-01(A)
Publicité
Table des Matières
