Beta 1438DCT/S Mode D'emploi page 11

- Install tool 1; keep it pressed and rotate it anticlockwise, until it locks (fig. 9).
- Keep tool 1 pressed and in position, while rotating the nut of tool 4 clockwise by using a
wrench (fig. 10), until it clicks; the clutch has thus been locked (fig. 11).
Caution: Keep tool 1 in position, to avoid damaging the clutch beyond repair.
- Remove tools 1 and 4.
- For the clutch to be properly locked, the 6 catches of clutch 2 must be in the correct position (fig. 11).
Visually check whether the fins and catches of clutch 2 have been fitted in correctly (fig. 12).
Caution: The catches must be in the correct position; otherwise, repeat the procedure
before installing the clutch, to prevent it from getting damaged beyond repair.
Fig. 11
Fig. 9
Fig. 10
Fig. 12