Publicité
6
Use
The following type of joint can be made with the jointing
system VS 600 and respective template:
• Dovetail joint
• Slotted box joint
• Dowel holes
• Open dovetail tenons
6.1
Dovetail joints
a)
Inserting the template
• Lock the tow swivel segments (6.1) in the central
(vertical) position with the clamping lever (6.2).
• Open both clamping levers (7.1, 7.3) to adjust the
height of the template and press the mount (7.2) for
the templates right down.
• Open the rotary knobs (7.4, 7.7) to clamp the template
and insert the template (7.5).
Caution: the two adjusting wheels (7.6) must point
downwards.
• Close the two claming levers to adjust the height of the
template.
• Align the template so that the lower shoulders (8.1) of
the two adjusting wheels rest against the base frame of
the jointing system and clamp the template tight with
the two rotary knobs (7.4, 7.7).
• Turn the two stops into the positions "SZ 14" and "SZ 20"
(9.3).
Align the stops so that the arrows (9.1) lie against
the inner straight side (9.2) of the notches in the
template.
Clamp the stops tight with the rotary knobs (9.4).
• Open the two clamping levers to adjust the height of
the template and move the template upwards.
• Place a workpiece under both ends of the template. Press
the template down until it rest fl at on the workpiece
and close the two clamping levers to adjust the height
of the template.
20
(see Chapter 6.1),
(see Chapter 6.2),
(see Chapter 6.3),
(see Chapter 6.4).
Publicité
