Continuous-feed shredder
W Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuousfeed shredder, wait until the
drive has come to a standstill and pull out
the mains plug. Do not reach into the feed
tube.
Warning!
The continuous-feed shredder must be
completely assembled before use. Never
assemble the continuous-feed shredder on
the base unit. Operate the continuous-feed
shredder in the indicated operating position
only.
Predetermined breaking point
Fig. F:
The built-in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the con-
tinuous-feed shredder breaks. However, the
drive shaft can easily be replaced. A new
disc holder with drive shaft is available from
customer service.
Reversible slicing disc –
thick / thin
for slicing fruit and vegetables.
Process at setting 5 (3).
Designation on the reversible slicing disc:
"1" for the thick slicing side
"3" for the thin slicing side
Warning!
The reversible slicing disc is not suitable for
slicing hard cheese, bread, rolls or choco-
late. Slice boiled, waxy potatoes only when
they are cold.
Reversible shredding disc –
coarse / fine
for shredding vegetables, fruit and cheese,
except for hard cheese (e.g. Parmesan).
Processing at setting 3 (2) or 4 (3).
Designation on the reversible shredding
disc:
"2" for the coarse shredding side
"4" for the fine shredding side
123_MUM58xxx_8001027204.indb 23
Warning!
The reversible shredding disc is not suitable
for shredding nuts. Shred soft cheese with
the coarse side only at setting 7 (4).
Grating disc – medium-fine
for grating raw potatoes, hard
cheese (e.g. Parmesan), cooled chocolate
and nuts.
Process at setting 7 (4).
Warning!
The grating disc is not suitable for grating
soft cheese and cheese slices.
Working with the continuous-feed
shredder
Fig. G:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the drive of the
continuous-feed shredder (Fig. G-5a).
■ Hold disc holder at the lower end, ensur-
ing that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. G-6a).
In the case of reversible discs, ensure
that the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. G-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous-feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. G-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
Operation
en
23
26.11.2015 16:10:31