Titan XL255 Mode D'emploi page 15

1. Lock the gun and remove spray tip assembly.
Submerge suction set into a bucket with appropriate
cleaning solution.
3. While pulling the gun trigger, turn the pump ON (l),
and turn the PRIME/SPRAY knob to SPRAY to purge
material from the hose back into the original container.
Keep holding trigger through next steps.
4. When cleaning solution flows from the spray gun, keep
holding the trigger and aim the spray gun into the side
of the waste container (ground gun with a metal
container if flushing with flammable solvent).
5. Trigger the gun until the fluid flowing out of the gun
is clear. You may need to dispose and obtain new
cleaning solution.
6. Turn the PRIME/SPRAY knob to PRIME and trigger gun
once to relieve pressure.
Move on to Cleaning the Suction Set.
Cleanup -
oil-based materials
Bucket with
cleaning solution
2. Place a waste container next to the original material
container. Aim the spray gun into the side of the
original material container and hold the trigger.
Waste
container
Containers should
be touching
• Hold trigger
• Turn pump ON (l)
• Turn PRIME/SPRAY knob to SPRAY
Spray cleaning
solution into
waste container
15
Hold trigger
Original
material
container
Spray material into
original container
English