BLINDHEM STITCH
The blindhem stitch is primarily used for hemming curtains,
trousers, skirts, etc.
Settings
: Presser foot - Blind stitch foot
: Thread Tension Control: AUTO
- Regular blind stitch for normal woven fabrics
- Elastic blind stitch for soft, stretchable fabrics
1. With matching thread finish the raw edge. On fine fabric,
turn up and press a small ½" or less hem. On medium to
heavyweight fabrics overcast the fabric's raw edge.
2. Now fold the fabric as illustrated with the wrong side up.
3. Place the fabric under the foot. Turn the handwheel counter
clockwise by hand until the needle swings fully to the left. It
should just pierce the fold of the fabric. If it does not, adjust
the guide (B) on the blindhem foot (A) so that the needle
just pierces the fabric fold and the guide just rests against
the fold.
NOTE: In addition to the adjustment on the foot,
the stitch width control can be used. The stitch
width control changes the swing of the needle for a
more narrow or wider stitch.
Sew slowly, guiding the fabric carefully along the edge of
the guide.
4. When completed, the stitching is almost invisible on the
right side of the fabric.
NOTE: It takes practice to sew blind hems. Always
make a sewing test first.
MULTI-STITCH ZIGZAG
SETTINGS : Presser foot - General purpose foot
: Thread tension control - AUTO
This is a strong stitch because as its name implies, it makes
three short stitches where the normal zig-zag makes only one.
For this reason it is highly recommended for overcasting all
types of fabrics.
It is also ideal for bartacks, mending tears, patching, sewing
towelling, and attaching flat elastic.
NOTE: Mending a tear or overedging as shown in
illustration requires manual adjustment of the length
control.
38
Medium to heavyweight fabric
Tissus moyens et lourds
Middelzware tot zware stof
1
2
Under side
Under side
Envers
Envers
Onderkant
Onderkant
Fine fabric
Tissus fins
Fijne stof
1
2
Under side
Under side
Envers
Envers
Onderkant
Onderkant
3
4
Top side
Endroit
Bovenzijde
B
A