Télécharger Imprimer la page

Pari LC SPRINT Manuel page 6

Masquer les pouces Voir aussi pour LC SPRINT:

Publicité

Les langues disponibles

Les langues disponibles

C. NEBULIZER SET-UP
1.
Clean/Disinfect Nebulizer Cup:
D-E to clean and/or disinfect your nebulizer
prior to first use. Re-assemble nebulizer.
2.
Connect Tubing To Compressor:
of Wing Tip
tubing to the air outlet on the
®
compressor. It should fit snugly (Fig. A).
3.
Load Medication:
Open the Inspiratory Valve
Cap of nebulizer by lifting the cap (Fig. B).
Pour the prescribed dose of medication into
nebulizer cup. Never fill past the max. fill line
of 8 ml.
4.
Attach Mouthpiece or Mask:
mouthpiece, attach the mouthpiece to the
nebulizer outlet with the expiratory valve
facing up. Then attach the inspiratory valve
cap by pressing it firmly into the top of the
nebulizer (Fig. C). If using a mask, refer to the
mask instructions.
5.
Attach Tubing To Nebulizer Cup:
other end of the Wing Tip
of PARI LC
Sprint (Fig. D).
®
6.
Starting Treatment:
Sit in a relaxed, upright
position and turn the compressor "ON".
A
4 Questions? 1.800.FAST.NEB (327.8632) | PARI.com
Refer to Section
Insert one end
If using the
Firmly press
tubing to bottom
®
7.
Nebulizer Position:
Place the mouthpiece
on top of tongue and close lips around it.
Take slow, deep breaths. As you inhale, the
inhalation valve opens.
8.
Breathing:
For mouthpiece, inhale and exhale
slowly through your mouth. As you exhale,
the valve on the mouthpiece opens to allow
the exhaled mist to escape. For mask, place
mask over nose and mouth and inhale and
exhale slowly.
9.
Complete Treatment:
medication is gone or you hear a slight
"sputtering" sound. Turn compressor off.
WING TIP
TUBING
®
It is normal if moisture or condensation
appears in your tubing during a treatment. This
can be a natural effect of your environment's
temperature. If this happens, finish your
treatment and then disconnect the tubing from
the nebulizer. Leave the other end attached to
the compressor air outlet and let run for a few
minutes. The warm air from the compressor
will dry the inside of the tubing. Use a damp
cloth to wipe the exterior of the tubing.
B
Continue until the

Publicité

loading