Main Switch - RedMax BHB250P Manuel D'atelier

5.8.2 To assemble the control unit
1. Connect connector (B), make sure the seal closes
tightly to the control unit and then attach on the
cover (A).
2. Connect the connector to the control unit.
3. Assemble the main cables in the chassis. See
assemble the ESD cables on page 11
568 - 002 - 27.03.2018
A
B

5.9 Main switch

5.9.1 To disassemble the main switch
Note: Do not pull the wires.
1. Disassemble the main cables. See
the main cable on page 14
2. Remove the connection (A) from the main switch.
3. Assemble in the opposite sequence.
To
To disassemble
A
Repair instructions - 17