Repair Instructions; To Clean And Examine The Product Parts; To Disassemble The Nozzle; To Disassemble The Chassis - RedMax BHB250P Manuel D'atelier

5.1 To clean and examine the product parts

• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.

5.2 To disassemble the nozzle

• Turn the nozzle to loosen it from the blow pipe.

5.3 To disassemble the chassis

• Remove the 12 screws. Lift off the left chassis half,
the front cover (A) and the rear vent cover (B).

10 - Repair instructions

5 Repair instructions
A

5.4 Power trigger

5.4.1 To disassemble the power trigger
• Lift the power trigger control out of the chassis.
5.4.2 To assemble the power trigger
• Press in the pin on the main switch to make it easier
to put the power trigger control in its bracket. Make
sure the rear edge on the power trigger control
enters into the chassis.
B
568 - 002 - 27.03.2018