RedMax BHB250P Manuel D'atelier page 13

Note: Do not pull the wires.
1. Put the motor with cables and connection spring into
the motor housing. It is very important that the motor
is put in correctly. Make sure that the red (X) and
blue (Y) cables are connected to the right of the
connection spring (H). The white (Z) cable must be
connected to the left.
Z
H
X
2. Attach the motor in the motor housing with the 3
screws.
568 - 002 - 27.03.2018
Y
3. Connect the connector (H) to the connection spring
in the motor housing.
4. Attach the shaft (F) on the motor. Press on the fan
(G) with a maximum force of 9 kN and a minimum
force of 2 kN. Press the fan on the shaft until the fan
is 0 - 1 mm above the edge of the motor housing.
F
Min 0 mm
Max 1 mm
Note: Do not press down the fan more.
H
G
Min 2 kN
Max 9 kN
Min 0 mm
Repair instructions - 13