Main Cable - RedMax BHB250P Manuel D'atelier

5. Put the bushing/cables (E) into the groove in the
blow pipe. Attach the blow pipe in the motor housing
with the screws. Put the brushes/cables (D) in the
clamp on the blow pipe.
D
E
6. Put the blow pipe and motor housing in the chassis.
The heels of the engine housing must be put
correctly to close the product.
14 - Repair instructions
7. Connect connector (A) to the control unit. Make sure
not to cause damage to the connector (B) with
cables. Connect connector (C) to the connector
spring.

5.7 Main cable

5.7.1 To disassemble the main cable
Note: The flat cable to the keypad is easily damaged.
Note: Do not pull the wires.
1. Loosen the connection spring that is found in the
cover above the electronics. See
ESD cables on page 11
2. Disassemble the motor housing/blow pipe. See
disassemble the motor and the blow pipe on page
12
3. Loosen the screw and lift off the cover.
A
B
C
To disassemble
To
568 - 002 - 27.03.2018