5. Attach the screws for the battery connection. Attach
the screws holding the battery cable.
6. Assemble the cover above the electronics.
7. Assemble the motor housing/blow pipe. See
assemble the motor and the blow pipe on page 12
8. Assemble the connection spring. See
the ESD cables on page 11
5.8 Control unit
5.8.1 To disassemble the control unit
Note: Do not pull the wires. Use the screwdriver only on
the outer side of the connector. Make sure not to press
16 - Repair instructions
the screwdriver too far to it cause damage the connector
or the control unit.
1. Disassemble the main cables. See
ESD cables on page 11
2. Disconnect the connector between the main cables
and the control unit.
3. Lift the cover (A) and loosen the connector (B) from
the control unit. Carefully use a screwdriver to help
to loosen the connector if it is blocked.
To
To assemble
To disassemble
A
B
568 - 002 - 27.03.2018