Esd Cables - RedMax BHB250P Manuel D'atelier

5.5 ESD cables

5.5.1 To disassemble ESD cables
1. Loosen the connection (B) from the motor and the
connection (C) from the ESD cable from the
connection spring (A).
C
B
A
2. remove the ESD catch from the handle and carefully
loosen the cable from its bracket in the chassis.
5.5.2 To assemble the ESD cables
Note: Make sure the cables are put correctly to prevent
them from being caught between the chassis halves.
568 - 002 - 27.03.2018
Make sure the ESD cable is is put onto the clamps on
the chassis.
1. Put the ESD cable onto the handle. Make sure the
cable is put in the clamps in the chassis.
2. Connect the connection (C) from the ESD cable and
connection (B) from the motor to the connection
spring (A).
B
A
C
Repair instructions - 11