Publicité
Les langues disponibles
Les langues disponibles
GB
F
2.
Open the frame at the side closures (Fig. 1, Item 22) and fold it open.
3.
Always lower the handle in the cover before opening the basic device cover (Fig. 1.
Item16).
4.
Open the closure (Fig. 1, item 17) and fold open the cover of the basic device.
5.
Unroll the power cable and slide the cable grommet into the provided recess (Fig. 4).
ATTENTION: Do not close the cover if the cable grommet is not positioned
6.
Remove the spray attachment from the deposition tray. Unscrew the container from
the spray attachment.
7.
Align the ascending tube. (Fig. 5)
If the ascending tube is positioned correctly, the container contents can be sprayed
without almost any residue. When working on lying objects: Turn the ascending tube
forwards. (Fig. 5A)
Spraying work when working on overhead objects: Turn the ascending tube
rearwards. (Fig. 5B)
8.
Place the container on a paper base and fill in the prepared coating material.
Screw the container firmly onto the spray attachment.
9.
Reclose the cover of the basic device with the lowered carry handle.
10.
Open the Velcro fasteners (Fig. 1, Item 15) und unroll the air hose. Connect it to the
air hose connection (Fig. 3).
11.
Close the frame again
12.
Connect the front part of the gun and the gun handle to each other. (Fig. 6)
13.
Put the spray gun onto the gun holder (Fig. 1, Item 13).
14.
Switch on the main switch at the device (Fig. 1, item 14).
15.
Remove the spray gun from the gun holder and point it at the object to be coated.
ATTENTION: It is advisable to test spray cardboard or a similar material
16.
Press the On/Off switch at the gun handle (Fig. 7, item 2).
Three different spray jet settings can be chosen on the spray gun, depending on
the application and target object.
Selecting the Spray Setting
Fig. 8 A = horizontal flat jet
Fig. 8 B = vertical flat jet
Fig. 8 C = circular jet
Adjusting the desired Spray Setting (Fig. 9)
With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spraysetting
position (arrow). Then tighten the union nut.
WARNING!
18
18
correctly. The power cable could otherwise be damaged!
in order to determine the material and amount of air for an
optimal spray pattern.
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach surfaces
Danger of injury! Never pull the trigger guard while adjusting
the air cap.
ProjectPro 213 Extra
ProjectPro 213 Extra
Publicité
