Factory Settings; Disposal - salmson LRE Installation Et Mise En Service

English
13

Factory settings

14

Disposal

112
For the factory settings, see Tab. 12 below.
Menu Designation
no.
1.0.0.0 Setpoints
2.0.0.0 Control mode
3.0.0.0 p-v gradient
2.3.3.0 Pump
4.3.1.0 Base-load pump
5.1.1.0 Operating mode
5.1.3.2 Internal/external pump
cycling
5.1.3.3 Pump cycling time interval
5.1.4.0 Pump enabled/disabled
5.1.5.0 SSM
5.1.6.0 SBM
5.1.7.0 External off
5.3.2.0 In1 (value range)
5.4.1.0 In2 active/inactive
5.4.2.0 In2 (value range)
5.5.0.0 PID parameter
5.6.1.0 HV/AC
5.6.2.0 Emergency operation speed
5.6.3.0 Auto reset time
5.7.1.0 Display orientation
5.7.2.0 Pressure value correction
5.7.6.0 SBM function
5.8.1.1 Pump kick active/inactive
5.8.1.2 Pump kick interval
5.8.1.3 Pump kick speed
Tab. 12: Factory settings
Proper disposal and recycling of this product prevents damage to the
environment and risks to personal health.
Disposal in accordance with the regulations requires the product to be
drained and cleaned.
Lubricants must be collected. The pump components are to be sepa-
rated according to material (metal, plastic, electronics).
1. Use public or private disposal organisations when disposing of all
or part of the product.
2. For more information on proper disposal, please contact your local
council or waste disposal office or the supplier from whom you
obtained the product.
Factory-configured values
• Controller:
approx. 60% of n pump
max
• p-c:
approx. 50% of H pump
max
• p-v:
approx. 50% of H pump
max
p-c activated
Lowest value
ON
MA
Main/standby mode
Internal
24 h
Enabled
Collective fault signal
Collective run signal
Collective external off
0–10 V active
OFF
0-10 V
See chapter 9.4 "Setting the con-
trol mode" on page 97
HV
approx. 60% of n pump
max
300 s
Display on original orientation
Active
SBM: Run signal
ON
24 h
n
min
Salmson 11/2017