Intended Use - Becker Centronic SensorControl SC861 Notice De Montage Et D'utilisation

The sensor described in these instructions must only be used for operating
Centronic-compatible radio drives and radio control units. The sensor is only
intended for operating sun protection systems that are not used as privacy
systems at the same time. Use for other purposes or for purposes beyond the
above constitutes improper use.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
• Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
•
Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

15 - en