Diameter Of Connecting Pipes; Refrigerant Charge For A Correct Functioning - Teddington CS620 Serie Mode D'emploi

CS
MODEL
CS190 TCR
CS300 TCR
CS440 TCR
CS620 TCR
16.3.1

Diameter of connecting pipes

CS190 TCR
CS300 TCR
CS440 TCR
CS620 TCR
16.3.2

Refrigerant charge for a correct functioning

MODELLO
CS190 TCR
CS300 TCR
CS440 TCR
CS620 TCR
M.CS620-00 ITA-ENG-FR 24/05/2021
It is recommended to install the outdoor unit in consideration of the preferred wind
direction.
The installations are not recommended in figure A, the installations as in figure B
should be preferred.
In order not to compromise the good operation of the unit and its performance,
install the external condenser considering the spaces indicated in figure C for
vertical installations, and in figure D for horizontal installations.
The external condenser must be positioned at a maximum height of 8 meters with
respect to the indoor unit ( see figure E ).
If the external condenser is positioned lower down inside unit , this height must
not exceed 2 meters ( see figure F ).
The maximum length of the pipes between the two units must not exceed 12
The slope of the pipes must be at least 2% to ensure the correct return of the
oil to the compressor. ( see figure G ).
MODEL
For a correct functioning of the unit for each meter of liquid line, add the quantity of
refrigerant indicated in the table below.
Warning: Before loading the unit, check the type of refrigerant indicated on the data plate
MEASURES
D [ mm ]
350
500
500
630
PIPING
GAS LINE [ mm ]
16 X 1
22 X 1
22 X 1
22 X 1
REFRIGERANT TYPE
R410a
R407c
R407c
R407c
L [ mm ]
410
833
833
883
meters.
LIQUID LINE [mm]
12 X 1
12 X 1
12 X 1
12 X 1
QUANTITY [ gr ]
100
100
100
100
91
EN