Blackmagic Design Teranex Manuel D'utilisation Et D'installation page 14

AES/EBU Audio Channels
13-16
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings
that are available using the switches, plus additional
settings. You can access these settings by moving between
the 'video,' 'audio,' 'configure,' and 'about' tabs.
The 'about' and 'configure' tabs are detailed in the 'changing
settings' section in this manual. The 'video' tab for Teranex
Mini SDI to HDMI 12G contains the following settings.
Video output menu
‚ Clip HDMI Output to legal levels
This checkbox controls clipping of your SDI input
to ensure that it stays within HDMI legal levels and
should be kept on by default.
The 'audio' tab for Teranex Mini SDI to HDMI 12G contains
the following settings.
Audio output menu
‚ Set XLR Output
You can choose between analog and AES/EBU
output by highlighting the 'analog,' 'AES/EBU,' or
Switch 4
OFF
Adjust your analog audio levels and AES/EBU levels using the 'audio'
settings page in Blackmagic Teranex Setup.
Switch 3 Switch 2
ON ON
'timecode' buttons in the 'audio output' menu. When
you select 'timecode' the left XLR connector will
output analog audio, while the right XLR output will
provide a timecode signal.
‚ Depending on which audio output option you select,
you can then pick which audio channels of your SDI
input to send to your HDMI, AES/EBU, or Analog audio
output, as well as adjusting their gain per channel or
channel pair. If you are outputting AES/EBU audio
via both XLR connectors, you can select up to four
channels. If you are outputting analog audio, you
can select up to two channels. If you are using the
right XLR connector to output a timecode signal,
the left XLR connector will output one channel of
analog audio.
Your Teranex Mini will retain its last settings whether applied
via switch, Smart Panel or Teranex setup utility. If reverting
to switch control after removing the Smart Panel or updating
your converter's settings via software, you may need to
toggle individual switches for new settings to take effect.
14
Switch Diagram