Blackmagic Design Teranex Manuel D'utilisation Et D'installation page 28

Analog Audio Channels
15-16
AES/EBU Audio Channels
1-4
5-8
9-12
13-16
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings
that are available using the switches, plus additional settings.
You can access these settings by moving between the
'audio,' 'configure,' and 'about' tabs.
The 'about' and 'configure' tabs are detailed in the 'Changing
settings' section in this manual.
The 'audio' tab for Teranex Mini SDI to Audio 12G contains
the following settings.
Switch 6
ON
Switch 6
OFF
OFF
OFF
OFF
Adjust your analog audio levels and AES/EBU levels using the 'audio'
settings page in Blackmagic Teranex Setup.
Switch 5 Switch 4
ON ON
Switch 5 Switch 4
OFF OFF
OFF ON
ON OFF
ON ON
Audio Output menu
This menu allows you to select between analog, AES/EBU,
and timecode audio outputs, as well as which channels of
your SDI audio input you wish to de-embed. You can also
adjust the gain on the audio output.
Your Teranex Mini will retain its last settings whether applied
via switch, Smart Panel or Teranex setup utility. If reverting to
switch control after removing the Smart Panel or updating
your converter's settings via software, you may need to toggle
individual switches for new settings to take effect.
28
Switch Diagram
Switch Diagram