Blackmagic Design Teranex Manuel D'utilisation Et D'installation page 20

by toggling switch 1. Component analog video supports
both HD and SD video.
Switch 4, 3 and 2 - SDI Audio De-Embed
Switches 4, 3 and 2 are represented as bits 2, 1, and 0
respectively. This simply means that by setting various on/
off combinations for switches 4, 3, and 2, you can choose
which pair of audio channels from your SDI input you would
like to output to analog or AES/EBU audio.
Switch 1 - Processing Off - Processing On
Down conversion with 3 types of aspect ratios by cycling
through switch 1. Toggle switch 1 between off and on to
cycle between anamorphic, center cut, and letterbox
aspect ratios.
When converting Ultra HD or HD, set switch 1 to 'off' to
force HD output via the analog component connectors.
You'll also need to make sure switch 5 is selected for your
desired output. For example, to select component output
set switch 5 to 'off'.
SDI Audio Selection Table
By using the following combinations of switch settings, you
can select which SDI audio channels to output as analog
Audio Channels
1 and 2
3 and 4
5 and 6
7 and 8
9 and 10
11 and 12
13 and 14
15 and 16
AES/EBU Audio Channels
1-4
5-8
9-12
4K DCI will be scaled on the component HD output.
The switch legend on the base of your converter gives you
all the information you need to change conversion settings.
or digital AES/EBU audio with your Teranex Mini SDI to
Analog 12G.
Switch 4 Switch 3
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
Switch 4 Switch 3
OFF OFF
OFF OFF
OFF ON
20
Switch 2 Switch Diagram
OFF
ON
OFF
ON
OFF
ON
OFF
ON
Switch 2 Switch Diagram
OFF
ON
OFF