Blackmagic Design Teranex Manuel D'utilisation Et D'installation page 13

Switches
Teranex Mini SDI to HDMI 12G's switches provide the
following settings:
Switch 8 - Analog Audio, AES/EBU Audio
Set switch 8 to 'off' to output balanced analog audio. Set
to 'on' for digital AES/EBU audio.
Switch 7 - Output Audio/Timecode
Set switch 7 to 'on' to output timecode via the R channel
audio XLR connector. Set to 'off' to output audio.
Switches 4, 3, 2 - SDI Audio De-Embed Bit 2, 1, 0
Switches 4, 3 and 2 are represented as bits 2, 1, and 0
respectively. This simply means that by setting various
on/off combinations for switches 4, 3, and 2, you can choose
which pair of audio channels from your SDI input you would
like to output to HDMI, analog or AES/EBU audio.
SDI Audio Selection Table
By using the following combinations of switch settings, you
can select which SDI audio channels to embed into your
Teranex Mini SDI to HDMI 12G's output signal.
Audio Channels
1 and 2
3 and 4
5 and 6
7 and 8
9 and 10
11 and 12
13 and 14
15 and 16
AES/EBU Audio Channels
1-4
5-8
9-12
The switch legend on the base of your converter gives you
all the information you need to change conversion settings.
Switch 4 Switch 3
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
Switch 4 Switch 3
OFF OFF
OFF OFF
OFF ON
13
Switch 2 Switch Diagram
OFF
ON
OFF
ON
OFF
ON
OFF
ON
Switch 2 Switch Diagram
OFF
ON
OFF