Parker Senso Control SCE - 0 20 Mode D'emploi page 52

4.3.4.1. Measurement reading queries on request
If the measurement readings are to be sent upon request to the
receiving instrument, then individual measurement readings can be
requested by sending the character R (Request).
M5 is selected with the + / - keys and the parameter selection is
activated with SET . Then set the scanning rate rAte = 000.0 with the
+ / - keys. The setting is ended with SET .
Send:
Character R from receiver (PC/PLC)
R once only
R five times
R ten times
Fig. 6: Data transfer between SCE-020-02 and
Control Unit
Receive:
Reading from
SCE-020-02
1 reading
5 readings
10 readings
Send readings
Request R
Readings query B/E
- 14 -
Receiver
PC or SPS