DAITEM DP8000 Serie Mode D'emploi page 40

I n s t a l l a t i o n
Wide gap contact D8921
Contact to screw
to the floor
60mm max.
Normally closed loop type.
Piezoelectric glass break sensor D8920
Detection: up to 2.5m
from the point of impact
2,5 cm
Normally closed loop type.
Suitable for all types of glass up to a
maximum of 6 mm thick.
Detection: up to 2.5 m from the point of
impact.
GB
Affixed with double sided adhesive pro-
vided, on clean, dry windows (cleaned with
a solvent) and at a temperature between +
21°C and + 38°C. Apply firmly. Adhere in a
corner of window, 2.5cm from the sides.
Operating temperature: -18°C to +38°C.
40
Sealed pressure mat contact, small
model D8926 and large model D8925
Magnet to screw to
the opening leaf
Normally open loop type.
Minimum weight to ensure closure of
contact:
- D8926: 35 kg,
- D8925: 40 kg.
2,5 cm
Roller shutter sensors
3 2 1
S
D8926
D8925
When connecting
!
a roller shutter
sensor, cut link S.
Locating roller shutter
sensors
This sensor is designed for traditional conti-
nental domestic roller shutters
inside the dwelling). It is strongly advised
against using them for renovated roller
shutters (casing outside the dwelling).
The sensor must be installed:
inside the protected area,
inside and at the centre of the casing of
the roller shutter,
with the roller cylinder as near as
possible to the opening of the casing,
the extremity of the cord fixed to the last
slat or the next to last slat of the roller shutter,
away from all sources of interference
(electricity meter...).
The sensor must not be installed:
outside the dwelling (renovated casings),
inside a metallic casing,
with the cord passing in the groove of
the roller shutter.
(casing
Daitem