DAITEM DP8000 Serie Mode D'emploi page 36

P r e p a r a t i o n
Choice of contact
It is not possible to install Normally
!
Open and Normally Closed contacts
to the same universal transmitter:
If the integrated contact is used, only NC
external contacts can be connected,
If the external contact is NO, the
integrated contact can not be used.
Position
of micro-
switches
O
N Integral contact only (NC)
1 2
O
Integral contact
N
+ external contact (NC)
1 2
O External contacts only (NO/NC)
N
or roller shutter sensor
1 2
Positioning micro-switch 1 and 2
!
to ON is not permitted.
GB
36
Example for a supervised transmitter, on zone number 3, using the integral contact only
(normally closed type: NC)
Transmitter code
Program the chosen transmitter code (succession of 8 numbers composed of 0's and 1's)
by pressing the "0" and "1" buttons as indicated below:
Contact
1st press
simultaneously
hold until the LED
extinguishes
Start of programming
!
Channel or zone number
1 2 3
1 0 0
2nd press
simultaneously
hold until the LED
extinguishes
0 1 0 1
if during the programming, more than 7 seconds separate 2 key presses or if the
press of the "0" and "1" keys at the start or end of programming is not simultane-
ous or long enough, the detector ignores the programming: the LED blinks to indi-
cate the programming is incorrect. The code programmed initially is preserved. It is
necessary to restart the programming of the detector code from the beginning.
Operating
mode
4 5 6
1 1 1
8 short successive Simultaneously press
presses and hold until the LED
corresponding extinguishes, then the LED
to the detection lights for 5s to
code chosen indicate correct
programming
. . .
End of programming
Type of Type of
contact sensor
7 8
0 0
0 1
Daitem