DAITEM DP8000 Serie Mode D'emploi page 34

P r e p a r a t i o n
Coding the transmitter
After having coded the control panel, carry out the coding of the transmitter using the 0 and
1 keys, the programming LED and the 2 micro-switches.
Assignment of the installation code.
In accordance with the position of the control panel's 10 installation code micro-switches,
complete the 10 empty boxes of the table below:
Installation code
with a 1 for the ON position of the micro-switch
with a 0 for the OFF position of the micro-switch
Example (not to be used)
Installation code
Program the installation code (succession of 10 numbers composed of 0's and 1's) by
pressing the "0" and "1" keys as indicated below:
Press and hold
GB
simultaneously
until the LED
extinguishes
0 1
Start of programming
34
1 2 3 4 5
O
N
1
O
N
1
O
N
1 2 3 4 5 6 7 8 9 10
1
0 1 1 1 1 0 0 1 1
1 2 3 4 5
1 0 1 1 1
Make 10 short
successive key presses
corresponding to the
installation code
. . .
6 7 8 9 10
6 7 8 9 10
1 0 0 1 1
Press and hold simultaneously
until the LED extinguishes then
the LED lights for 5s to
indicate correct programming
0 1
End of programming
if during the programming, more
!
than 7 seconds separates 2 key
presses or if the press on the "0" and "1"
keys at beginning or end of program-
ming is not simultaneous or long
enough, the transmitter ignores the
programming: if the LED blinks, the
programming is incorrect.
The code initially programmed is
preserved. It is necessary to restart the
programming of the installation code
from the beginning.
Daitem