DAITEM DP8000 Serie Mode D'emploi page 35

DP8211/DP8212
Programming of the channel or zone number, the operating mode, the type of contact and the type of sensor.
Complete the 8 empty boxes of the following table, using to the choices below:
1
Transmitter code
Choice of channel (1)
1 2 3 4 5
1 0 1 1 1 Intrusion 1 :
immediate triggering
1 0 1 0 1 Intrusion 2 :
delayed triggering
1 0 0 1 1 Intrusion 3 :
immediate triggering
1 0 0 0 1 Intrusion 4 :
delayed triggering
0 0 0 0 1 Pre-alarm: triggering of
the control panels integral
siren after the entry delay
(delay selected on the
control panel).
DP8340: 10 secs loud ring.
DP8360: 10 secs,
1) non-supervised detector
- Detector associated with the DP8340 control panel or
- Detector other than that of intrusion (Pre-alarm) associated with
the DP8360 control panel.
Channel or zone number
2 3
Choice of zone number (2)
Channel
1 2
1 0
1 0
1 0
1 0
1 1
1 1
1 1
1 1
1 0
1 0
1 0
1 0
0 1
attenuated
0 1
or loud ring.
0 1
(2) supervised detector for use
with DP8360 control panel only.
Operating
mode
4 5
Choice of
operating mode
3 4 5 N°
0 Non-supervised
1 1 1 1
mode
1 0 1 2
1 Supervised mode
0 1 1 3
(with DP8360 con-
0 0 1 4
trol panel only)
1 1 0 5
1 0 0 6
0 1 0 7
0 0 0 8
1 1 0 9
1 0 0 10
0 1 0 11
0 0 0 12
1 1 0 13
1 0 0 14
Only one detector per zone is permitted as
0 1 0 15
!
Type
of contact
6 7
Choice of
sensor type
0 NO/NC contacts
or no contact
1 Roller shutter
sensor
Choice of
contact type
0 Normally closed
contact (NC)
1 Normally open
contact (NO)
supervision errors will occur otherwise.
Type
of sensor
8
GB
35