Using The Laser Guide - RIDGID R4031 Manuel D'utilisation

ASSEMBLY
INSTALLING LASER BATTERIES
See Figure 20.
 Remove screw from battery compartment cover using
the Phillips end of the supplied arbor wrench. Remove
cover and set aside.
 Install two AAA batteries according to polarity indicators
inside the battery compartment.
 Replace the battery compartment cover. Reinstall screw
and tighten securely.

USING THE LASER GUIDE

See Figures 20 - 21.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein could
result in hazardous radiation exposure.
Using a straight edge or square, draw a mark on the tile
with a marker or grease pencil. Turn the laser on and off by
pressing the laser guide switch located on the side of the
"D" handle. When the laser is turned on it will generate a red
line on the work surface. This line will assist you in lining up
the mark for more accurate cutting of the tile.
NOTE: Laser may be difficult to see in bright sunlight.
With the wheel in the cutting position, move the tile until the
mark and the laser line are aligned.
Removing Your Mark:
Position the tile so that the laser line is near the left edge of
your mark in order to remove the mark.
To Cut Your Mark:
Position the tile so that the laser line is near or over your
mark in order to cut the mark.
To Leave Your Mark:
Position the tile so that the laser line is near the right edge
of your mark in order to leave the mark.
Make several practice cuts on different styles and thickness
of material. Repeat the steps as necessary.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning your mark with the laser line.
To adjust the position of the laser guide line, refer to the
Adjustments section later in this manual.
BATTERY
COVER
SCREW
• To reduce the risk of injury, the user must read and understand
operator's manual.
• Wear eye, hearing, and respiratory protection when operating the tool.
• Do not remove the wheel guard.
• Never operate the tool without the wheel guard securely closed.
• Turn off tool, wait for the wheel to stop moving and disconnect
the power to the tool before servicing, when changing cutting
wheels, or cleaning.
• Never use wheels that have openings, grooves, or teeth on this tool.
• Always inspect and replace damaged cutting wheels before operating
the tool.
• Do not expose to rain or other damp locations.
• Do not fill water bath above maximum water fill line.
• Do not stack or store tiles on water trays.
• Use splash hood for every operation for which it can be used.
COMPLIES WITH 21 CFR PARTS 1040.10 AND 1040.11
18 — English
LASER GUIDE
AVOID EXPOSURE:
Laser radiation is emitted from this
aperture.
RYLD
ÉVITER L'EXPOSITION :
Radiation laser émise de cet orifice.
640-670
EVITE LA EXPOSICIÓN:
La radiación láser se emite por
esta abertura.
SWITCH
Fig. 20
Fig. 21