RIDGID R4031 Manuel D'utilisation page 14

ASSEMBLY
INSTALLING MOTOR HEAD AND BASE TO
WATER TRAY
See Figure 8.
 Rest pump power cord and water hose in the notches
provided on the water tray.
 Carefully lift the motor head and base assembly over the
water tray, as shown.
 Place the frame on the water tray as shown being careful
not to pinch the pump power cord or water hose.
INSTALLING THE SLIDING TABLE
See Figures 9 - 10.
To Unlock the Sliding Table:
 From the right side of the table, pull the table lock lever
out and turn the lever toward the back of the saw.
To Install the Sliding Table:
 Grasp the table firmly and set the left side rollers of the
sliding table on the rails then push the table toward the
back of the saw.
 Gently set the right side rollers of the sliding table on the
rails.
 When the table lock lever reaches the stop on the front
rail on the right hand side of the frame, pull the lever out
and hold it out until the lock has passed the stop. Release
the lever.
 Slide the table along the rails until the final rollers engage
the rails.
To Lock the Sliding Table:
 Turn the table lock lever until the lever points "up".
 Release the lever.
NOTE: When the table is installed on the water tray frame
and you push the table, it will "click" into place. This is the
table lock lever snapping into a hole in the frame locking
the table in place.
WATER
HOSE
PUMP
POWER
CORD
TABLE LOCK
LEVER
SLIDING
TABLE
SAW
FRONT
14 — English
FRAME
WATER
TRAY
LOCK
Fig. 8
UNLOCK
Fig. 9
ROLLERS
Fig. 10