Operating The Pallet Truck Scale; Straight Weighing - Mettler Toledo BTA231 Manuel Utilisateur

3
3.1
12
User Manual BTA231
METTLER TOLEDO

Operating the Pallet Truck Scale

Straight Weighing

Preparation:
• Turn on the terminal and check its status:
- When there is no load on the forks, the terminal
displays "0 kg"
- When there is load on the forks, the terminal displays
the weight
• Lower the forks to lowered position
To Weigh: Set the control lever in ASCENT position. Push the
lowered forks into the pallet. For safety reasons, the load should
be placed centrally across the forks and not at the end of the
forks. Lift the forks until the pallet and load are entirely off the
ground (at least three full pumping strokes). Insure that there
are no peripheral items or obstacles touching or contacting the
pallet, the forks, or the load. The stable reading displayed on
the terminal is the gross weight.
Note: Make sure that the pallet truck scale is on a level (con-
crete) surface when weighing or transporting loads. The maxi-
mum slope of the floor should be less than 2%.
Mechanical Operations
Lift: Set the control lever in ASCENT position. Push the
lowered forks into the pallet taking caution to insure
the load is placed centrally across the forks and not
at the end of the forks. Pumping the handle will lift
the load.
Move: Set the control lever in NEUTRAL position. Pulling the
handle will move the load.
Lower: Set the control lever in LOWER position. The forks will
descent to lowest position.
Order number 30088256 08/13